$795.00
Our P/N 9940 and P/N 10156 carrier cards allows use of a PMC in a PCI express edge card slot. The product features a PI9X130 bridge chip four lane PCI Gen 1 (2.5Gb/s) express primary side and a PCI/PCI-X secondary side.
Datasheet, 9940_datasheet
5 in stock
The 9940 and 10156 carrier cards allows use of a PMC in a PCI express edge card slot. The product features a PI9X130 bridge chip four lane Gen. 1 PCI express primary side and a PCI/PCI-X secondary side.
The 1 lane P/N 10156 fits in 1, 4, 8 and 16 lane PCI Express slots. The 4 lane Technobox P/N 9940 fits in 4, 8 and 16 lane PCI Express slots. The 10156 is a replacement for the one lane P/N 4749, but since 10156 is 5V PCI signaling compatible is also a suitable replacement for P/N 5243.
The PCI/PCI-X secondary side operates at 33, 50, 66, 100 or 133 MHz in 64 or 32 bit bus width mode. For rear I/O applications the 64 user rear I/O signals on the PMC PN4 connector are available at the A and C rows of a 96-pin DIN connector.
An optional triple fan assembly (P/N 9983) is available that fits over two PMC-to-PCI express adapter boards and provides substantial forced-air cooling of high-power PMC modules.
This bridged adapter needs no additional software support since PCI Express is backward compatible with PCI software. Software support for the PMC in use is provided by the PMC supplier.
This product works with or 3V or 5V PCI signaling PMC cards, by moving a voltage key and jumper. Several activity LEDs give an indication of key PCI and PCI express signals and voltages. The XCAP and M66EN signals are supported by jumper population to force operation at non-X or lower PCI clock frequencies.
A high-quality 2.5 mm thick machined aluminum panel, with a 0.5 mm chamfered edge, is provided on the PCI board bracket. This mimics the mechanics of a PMC installed on a VMEbus board or other host environments and allows the PMC bezel to be firmly positioned on the board. The following sections describe these features in more detail.
CAUTION: It is important to make sure the signaling environment of the PMC card is 3.3V , 5V or dual 5V/3.3V. The mechanical key must be moved to the correct location for 5V PMC or 3.3V PMC cards.
*Diodes Inc is the current producer of the PI7C9X130, it was originally made by Pericom which was acquired.
